Model G0767 (Mfd. Since 1/14)
-25-
7. Using angle scale, rotate vise to desired
angle of notch (from 90° to 30° in relation to
front profile roller), then retighten both cap
screws.
8. Use crank handle (see Figure 30) to adjust
space between clamp plate and jaws to
accept tube.
When mounting tubes longer than 3', have
another person support end of tube. This
will reduce risk of tube unexpectedly coming
loose in vise during operation and causing
impact injuries or property damage.
6. Loosen vise cap screws shown in Figure 29.
Figure 29. Vise angle controls.
Cap
Screws
Angle Scale
9. Insert tube between jaws and clamp plate
(see
Figure 31), making sure tube extends
far enough that notching operation can be
performed without vise contacting belt.
10. Loosen clamp lever (Figure 30), then use
crank handle to position clamp plate within
1
⁄
16
" of tube.
11. Tighten clamp lever to lock tube in place.
Note: If it is too difficult to secure tube with
clamp lever, use crank handle to slightly
increase distance between clamp plate and
tube, then try again.
12. Position spark shield over profile roller and
lock it in place (see
Figure 30).
Figure 31. Tube inserted in vise.
Figure 30. Vise clamping controls.
Clamp Lever
Jaws
Clamp
Plate
Spark Shield Lock Handle
Crank
Handle
In next step, make sure tube end you plan
to notch is protruding far enough out of
vise that vise will not contact belt during
operation. Otherwise, property damage
may occur.
Summary of Contents for G0767
Page 48: ......
