Grizzly G0668, Owner'S Manual, Page: 42 / 60

-40-
G0668 20" Vertical Metal-Cutting Bandsaw
��������
�������������
��������
������������
������������
����������
������������
�������������������������������
�������������������������
�����������������
Figure 49. Examples of wheel orientation to one another.
table alignment
Aligning Table to
Blade
To ensure the angle accuracy of the cut, the table
must be 90° to the blade from front-to-back and
side-to-side. If the table is not square to the blade,
it needs to be adjusted.
Tools Needed: Qty
Hex Wrench 5mm .............................................. 1
Wrench 12mm ................................................... 1
To adjust the table square to the blade:
1. DISCONNECT BANDSAW FROM POWER!
2. Make sure the wheels are correctly aligned
(
Page 38
) and the blade is properly ten-
sioned ( Page 25 ).
3. Set the angle of the table to "0".
4. Use a square to check table alignment with
the side and the back of the blade, as shown
in
Figure 50 .
Figure 50.
Checking table alignment with the
blade.