Grizzly G0593, Instruction Sheet

Page: 1 / 50

INTRODUCTION
The Model G0593 is the spiral cutterhead ver-
sion of the G0586. Except for differences noted
in this insert, all other content in the Model G0586
owner's manual applies to this machine. Before
operating your new machine, you MUST read
and understand this insert and the entire Model
G0586 manual to reduce the risk of injury when
using this machine.
If you have any questions about this manual
insert or the differences between these two mod-
els, contact our Technical Support at (570) 546-
9663 or email techsupport@grizzly.com.
The spiral cutterhead consists of 36 indexable
carbide inserts. Each insert has four cutting
edges, which can be easily rotated if the current
cutting edge becomes dull or damaged.
INVENTORY
For the Model G0593, use the inventory list from
the Model G0586, but exchange the standard
cutterhead parts for the parts below:
Flat-Head Torx Screws ....................................10
Torx Screw Driver T-Handle 6mm .....................1
Torx Bits T-25 ....................................................5
Carbide Inserts ..................................................5
REPLACING or ROTATING INSERTS
To replace or rotate the inserts:
1. Disconnect the jointer from the power
source.
2. Clean out the heads of the insert Torx screws
that you wish to replace or rotate.
3.
Remove the Torx screw, replace or rotate the
insert, lubricate the threads of the Torx screw
with a light machine oil, and torque the screw
to 50 inch pounds to tighten the insert.
INSTRUCTION SHEET
Model G0593
Spiral Cutterhead
8" x 75" Jointer
Figure 2.
Rotating indexable carbide inserts.
Figure 1.
Spiral cutterhead and close up of
carbide insert.
NOTICE
Make sure there is no wood dust or debris under
insert when replacing it.
NOTICE
Over-tightening Torx screws may strip the
cutterhead threads!