Grizzly g0531b, Owner'S Manual, Page: 2 / 100

Model G0531B/G0566B (Mfd. Since 09/18) -2-
Test Run
1. Follow Steps 1-3 in the G0566 Manual on
Page 24.
2. Verify that the machine is operating cor-
rectly by turning the switch disabling key (see
Figure 4) to "1" and turning the machine ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
3. Press the OFF button to stop the machine.
4. WITHOUT resetting the OFF button, press
the ON button. The machine should not
start.
—If the machine does not start, the OFF but-
ton safety feature is working correctly.
—If the machine does start (with the stop
button pushed in), immediately disconnect
power to the machine. The OFF button
safety feature is not working correctly. This
safety feature must work properly before
proceeding with regular operations. Call
Tech Support for help.
Figure
4
. G0531B switch disabling key and ON/
OFF switch.
4. Tighten hex nut on fence handle against
fence pivot block (see Figure 2).
5. Install resaw fence lock handle (with 8mm
washer and sliding plate) onto fence, then
slide resaw fence over sliding plate as shown
in
Figure 3.
Note: Leave moving plate and lock handle
loose enough to slide onto resaw fence.
Figure 2. Fence handle components.
Pivot Block
Hex Nut
Fence
Handle
6. Tighten resaw lock handle.
7. Pull fence handle up and place fence assem-
bly on rail.
8. Push fence handle down to lock fence assem-
bly in place.
Figure 3. Example of attaching resaw fence to
standard fence.
Resaw Fence
Resaw Lock
Handle
Sliding
Plate