"()"
<%*&)M$"M'$"M'7$"M(B[\#H^cXZ'$&'
4.
AddhZc i]Z XVe hXgZl dc i]Z aViZgVa VY_jhi"
bZci gdY VcY VY_jhi i]Z WaVYZ \j^YZh jci^a
i]ZZY\Zhd[i]ZWZVg^c\hVgZ
&
$
&+
WZ]^cYi]Z
WaVYZ\jaaZih!Vh^aajhigViZY^c
Figure 56
#
Note:
The
1
/
16
" spacing is ideal, although with
larger blades it may not be possible. In such
cases, adjust the guide bearings as far for-
ward as possible to the blade gullets, and still
maintain the proper support bearing spacing
adjustment.
3.
;Vb^a^Vg^oZndjghZa[l^i]i]ZWaVYZ\j^YZXdc"
igdahh]dlc^c
Figure 55
#
5.
I^\]iZc i]Z XVe hXgZl dc i]Z aViZgVa VY_jhi"
bZcigdY#
6.
AddhZc i]Z WZVg^c\ gdiVi^dc VY_jhibZci XVe
hXgZlh#
7.
GdiViZ i]Z `cjgaZY `cdW id edh^i^dc i]Z
WZVg^c\h%#%%)VlVn[gdbi]ZWaVYZ#
Note:
0.004" is approximately the thickness of a
dollar bill.
8.
I^\]iZci]ZXVehXgZlidadX`i]ZWaVYZ\j^YZ
WZVg^c\h^cedh^i^dc#
9.
GZeZVii]^hegdXZYjgZ[dgi]ZadlZg\j^YZh#
Figure 55.
7aVYZ\j^YZXdcigdah#
7ZVg^c\GdiVi^dc
6Y_jhibZci8Ve
HXgZl
AViZgVa
6Y_jhibZci
GdY8Ve
HXgZl
@cjgaZY
@cdW
7aVYZ<j^YZ
7ZVg^c\h
Figure 56.
AViZgVaVY_jhibZcid[WaVYZ\j^YZh#
7aVYZ
<jaaZi
Make sure that the blade teeth will not con-
tact the guide bearings when the blade is
against the rear support bearing during the
cut or the blade teeth will be damaged.
Whenever changing a blade or adjusting
tension and tracking, the upper and lower
blade support bearings and guide bearings
must be properly adjusted before cutting
operations.
Summary of Contents for EXTREME G0514X
