Grizzly BRM 46-141 A-OHV, Translation Of The Original Instructions For Use

Page: 96 / 172

96
UK
1. Disconnect the spark plug con -
nector (12) from the spark plug
(13) by simultaneously pulling
and turning.
2. Unscrew the spark plug (13) an-
ticlockwise using the enclosed
spark plug wrench ( 27).
3. Check the spark gap using a
feeler gauge (available from
specialist shops). The spark gap
must be at least 0.5-0.6 mm.
4. If necessary, adjust the gap by
carefully bending the ground
electrode on the spark plug.
5. Clean the spark plug with a wire
brush.
6. Insert the cleaned and adjusted
spark plug or replace a dam -
aged spark plug with a new one
(recommended torque 20 Nm,
determined with a torque
wrench) (see “Replacement
parts/Accessories“).
Changing the Engine Oil
Change the engine oil with the
petrol tank empty and the engine
warm.
• Change the engine oil for the
first time after around 5 operat -
ing hours then every 50 operat -
ing hours or annually.
• Dispose of the used oil in an
ecofriendly manner (see “Dis -
posal/Environmental protec -
tion“).
1. Remove the spark plug connector
( 12) (see “Maintaining the Spark
Plug”).
2. Open the oil tank cover ( 19) and
pump out the motor oil with an oil
pump.
3. Refill with engine oil (see “Initial Op -
eration”).
Checking/Sharpening/Replac-
ing the Blade
Only allow specialist companies to
install and dismantle the knife.
Wear gloves when handling the
blade.
• Take off the spark plug connector (
12) and check the blade for wear and
damage.
• Always have a blunt blade resharp -
ened by a specialist company, as an
imbalance check can be carried out
there.
• Always have a specialist workshop
change a damaged or imbalanced
blade.
Incorrect installation can result
in serious injury.
Adjusting the Carburettor
The carburettor has been preset in the
factory for optimum performance. If read -
justments are required, have the adjust -
ments made by a specialist workshop.