-12-
g5770 36" slip roll 22 gauge
Assembly
the Model g5770 comes from the factory almost
fully assembled. all that is required to assemble
are the crank and handle.
to assemble your machine:
1. thread the crank handle into the small end of
the crank and tighten, as shown in
figure 6.
Mounting
once you have confirmed that your machine is
assembled and functioning properly, mount it to a
workbench through the holes in the base.
the strongest mounting option is a "through
Mount" where holes are drilled all the way through
the workbench, and hex bolts, washers, and
hex nuts are used to secure the machine to the
workbench.
-ACHINE"ASE
7ORKBENCH
7dai
;aViLVh]Zg
;aViLVh]Zg
AdX`LVh]Zg
=ZmCji
figure 8. example of a through mount setup.
-ACHINE"ASE
7ORKBENCH
AV\HXgZl
;aViLVh]Zg
figure 9. example of a direct mount setup.
another option for mounting is a "direct Mount"
where the machine is simply secured to the work-
bench with lag screws.
figure 6. Crank assembly.
2. slide the crank onto the crank shaft until the
crank stops against the beveled shoulders of
the shaft. insert and tighten the M8-1.25 x 40
hex bolt to secure the crank in place (
figure
7).
Crank
Crank handle
figure 7. Crank mounting.
Crank shaft
Crank
hex Bolt
