Griven PARADE MK3 D-RGB, Instruction Manual, Page: 20 / 24

20 English
Parade can operate without DMX signal (in AUTOMATIC mode) and can be set so that a single MASTER unit will
command a series of SLAVE units. This function is particularly useful when more units are desired to execute the
same programme in synchrony.
The following picture shows an example of a Master-Slave layout.
6.1 MASTER configuration
To set up the unit as MASTER/AUTOMATIC, set the dip-switch Master to ON.
The unit will execute the pre-configured colour changer program.
The following pictures show some examples of MASTER units configuration.
6.2 SLAVE configuration
To set up the unit as SLAVE adjust all the dip-switches to OFF.
If the unit is properly set up as SLAVE and the signal is present, the red led next to the dip-switch panel will con-
stantly remain on.
The following picture shows an example of configuration of SLAVE units.
6.0 Master-Slave and Automatic function
MASTER SLAVE 1 SLAVE N
IN OUT IN OUT
SLAVE 2
IN OUT
Terminal resistor
120 Ohm
Unit set as Master (Master = ON)
1 2 3 4 5 6 7 8 9 10 11 12
1 2 4 8 16 32 64 12
8
25
6
N
.C
.
M
as
te
r
C
H
m
od
e
Attenzione!
If MASTER-SLAVE mode is being used, no other DMX control device must be present along the line!!
Slave unit (All witch = OFF)
1 2 3 4 5 6 7 8 9 10 11 12
1 2 4 8 16 32 64 12
8
25
6
N
.C
.
M
as
te
r
C
H
m
od
e