English
25
10.3 DMX signal interruption
If the DMX signal is absent the shutter will close and the motors will stop in 5 minutes from the last signal reception.
10.4 Lamp management by DMX signal
In the presence of DMX, the lamp is controlled by the 1st channel dmx.
To turn off the lamp via DMX you need to stay at least 4 seconds in the 0-63 area of the DMX channel 1.
To turn on the lamp, allow at least 20 s after switching off.
Gobostorm Plus MK2
can operate without DMX signal (in AUTOMATIC mode) and can be set so that a single
MASTER unit will command a series of SLAVE units. This function is particularly useful when more units are desired
to execute the same programme in synchrony.
The following picture shows an example of a Master-Slave layout.
11.1 AUTOMATIC configuration
See paragraph 9.4 AUTOMATIC configuration.
11.2 MASTER configuration
To set up the unit as MASTER the same instructions for the set up as AUTOMATIC must be followed (see paragraph
9.4 AUTOMATIC configuration).
11.3 SLAVE configuration
To set up the unit as SLAVE set the DMX address 001. See paragraph 9.3 DMX setting
11.0 Master-Slave and Automatic function
MASTER
SLAVE 1
SLAVE N
IN
OUT
IN
OUT
SLAVE 2
IN
OUT
Terminal resistor
(R=120
ƺ
not included!)
Summary of Contents for GR0660
Page 1: ...GOBOSTORM PLUS MK2 GR0660 Instruction manual ...
Page 2: ......
Page 31: ...NOTES English 31 ...
