Connect the DMX signal cables to the pin
“6”
.
6.4 Projectors connection
The Transformer Box has been designed to run a maximum number of 4 units of the Waterled MK2.
The unit is fitted with pins for the connection of the projectors, as shown in the following pictures.
Connect the projectors cables to the pin
“7”
.
The connection of the cable to the unit must be performed respecting the label next to the terminal box,
6.5 Powering up the unit
After performing all the actions described in the previous paragraphs, it is possible to proceed and power up the
unit.
In case of DMX signal connected, the LED will be steady on, while in the absence of DMX signal the LED will off.
Pin 1: GND
Pin 2: DATA-
Pin 3: DATA+
6
Warning!
All data wires must be isolated one from another, from the shield and from the metal housing of the connectors.
Pin number 1 of the housing is not to be connected to the electric ground of the unit.
Insert a terminal plug with a 120 Ω resistor connected to pins 2 and 3 in the last unit.
7
DATA-
DATA+
VDC+
VDC-
GND (HOSE)
English
19
