28
English
5.1 Setting operating mode
By the dip-switch set it is possible to select one of the following operating modes:
• using DMX512 signal control mode
Each fixture is controlled from DMX512 signal control.
• MASTER-SLAVE or AUTOMATIC mode
The projector operates independently, without DMX512 signal control.
5.2 Setting DMX address
To access to the dip-switch panel it is necessary untighten the
screw
“6”
and remove the box cover.
One led is next to the dip-switch panel to notify the status of the
unit.
In the presence of DMX signal, the red led “16” will be steady on,
when the projector functions as master, the red led will flash,
while in the absence of the signal the led will remain off.
When power is connected, the green LED "17" will always be on.
The number of DMX channels used by the unit to operate will depend from the selected operating mode.
In case of more units operating in mode
CH MODE = 1
, the first unit will be set with address 001, the second unit
with address 004, the third unit with address 007, etc.
In case of more units operating in
CH MODE = 2
mode, the first unit will be set with address 001, the second unit
with address 005, the third unit with address 009, etc.
The number of the DMX address is to be calculated by summing the values corresponding to the activated dip-
switches, which are written in the upper side of the dip-switch set (1, 2, 4, 8, 16, etc.).
5.0 Use of the unit
6
16
17
DIP 10
DIP 11
DMX MODE
DMX CHANNELS USED BY THE UNIT
OFF
OFF
1
3
OFF
ON
2
4
ON
OFF
3
1
ON
ON
4
2