SETUP
Press Cancel button to turn power on.
To start you need to select one of the three
units of measurement; In-Lbs, Ft-Lbs, N-m.
Press the Menu button and scroll to the Unit
window. Using Up and Down arrows, select
your unit preference.
Next, press Menu button again until window
shows "nodE" and then select the operating
mode.
P
EAK
H
OLD
M
ODE
- (M
AIN
O
PERATING
M
ODE
)
During this mode of operation the LCD will
show the maximum torque value applied to
the fastener. Once displayed you must push
the Cancel button to clear the reading in
preparation for the next fastener.
T
RACK
M
ODE
Track mode will display the real time torque
as the wrench is in operation. Track mode
data will only display on the LCD while in
use, and resets to zero when use is discon-
tinued.
The wrench will auto sleep after 2 minutes
idle for power saving. Press Cancel button to
resume use of the torque wrench.
R
ESETTING
T
ORQUE
W
RENCH
Press Cancel and Up Arrow buttons at the
same time to reset the torque wrench.
L
OW
B
ATTERY
Replace the battery when the low battery
indicator is shown in the upper left corner of
the LCD window.
CARE AND STORAGE
1. Do not store wrench exposed to high heat,
humidity, or direct sunlight.
2. Do not use torque wrench under wet
weather conditions or near standing water.
3. If the wrench gets wet, wipe it dry as soon
as possible.
4. Avoid solvents, such as alcohol or paint
thinner to clean the wrench.
