American Metal Ware
®
P400GNB-E
Page 10
Care and Cleaning
Cleaning After Each Brew
Dispose of grounds and rinse brew baskets. Rinse shuttles before using them again.
Daily Cleaning
The following cleaning procedure should be done on a daily basis.
1) Turn both warmer switches off. Remove the shuttle, and drain any remaining coffee from it. Thoroughly clean
the shuttle and the sight glass. Rinse and let air dry. Do not place the shuttle back on the warmer.
2) Remove the brew baskets from each side. Discard any contents in brew baskets. Clean and rinse the brew
baskets. Do not place them back on the unit.
3) Remove the spray head assembly from the spray tee assembly
(refer to Figure D). Pull the tab located at the front of the spray
head until it hits the forward stop. The sprayhead will drop
straight down and away from the spray tee nut. Clean and rinse
the spray head assembly and let air dry.
4) Clean the inside of the spray dome around the grinder outlet
chute. Use the brush provided to clean the grinder outlet chute
(refer to Figure E). Move the finger tab on the shutter door
toward the rear. Use the brush to clean up inside the grinder out-
let chute above the shutter door.
IMPORTANT
: Do not insert the brush into the chute past
the stops on the brush.
Be sure to remove all the residue from the grinder outlet chute
both above and below the shutter door. Remove the brush and
release the finger tab on the shutter door.
5) Once the spray dome and grinder outlet chute are clean, the spray head assembly may be reinstalled onto the
spray tee outlet nut. Hold the tab forward on the spray head until it hits the stop. Place the spray head up
inside the spray dome. Release the hold down tab. Be sure it seats above the nut, then lock the spray head in
place inside the spray dome.
6) Do not replace the basket and shuttle on the unit. This allows the shutter mechanism to cycle and remove any
remaining residues overnight.
7) The following day, clean any coffee that may have fallen from the warmer area.
8) Place filters into the brew baskets, and install the baskets onto the unit. Place a clean shuttle onto each
warmer. Select the brew size and start the unit. Once the brew cycle has started, turn the warmer switches on.
NOTE
: Cleaning brush part number is
.
Cleaning During Regularly Scheduled Maintenance
To be done by a service technician during regular scheduled maintenance (not to exceed 6-month intervals)
! WARNING: BURN HAZARD
HOT LIQUIDS AND SURFACES ARE PRESENT IN THIS EQUIPMENT. TO AVOID BURNS
USE CAUTION WHEN CLEANING. RINSE HOT PARTS WITH COLD WATER BEFORE
CLEANING. USE GLOVES OR HEAVY CLOTH WHEN REMOVING HOT PARTS FROM
BREWER.
Figure D
Figure E
