Infierno 96/154
®
Installation & Use
INSTALLATION
4
UNLOADING & MOVING
USING A CRANE
The Infiernos travel in large crates. They may be lifted
while still in the crates using straps rated to at least 4,000
lbs. It also may be lifted after the crate is removed using
the same type of straps. The grill is very top and back-
heavy due to the large amount of fire brick lining the floor
and back. TAKE THIS WEIGHT DISTRIBUTION
INTO ACCOUNT WHEN LIFTING THE GRILL.
USING A FORKLIFT
Lift the grill from the rear, positioning the forks as widely
as possible under the center station of the Infierno grill.
The grill is very rear-heavy due to the large amount of
firebrick lining the floor and back. TAKE WEIGHT
DISTRIBUTION INTO ACCOUNT. The grill weighs
over 3,000 lbs, make sure the forklift is rated to
lift well in excess of this weight.
USING A PALLET JACK
You may use a pallet jack once the grill has been
removed from the delivery vehicle. Whether inside or
removed from the crate, make sure to lift from the back,
positioning the jack under the center of the grill spread as
wide a possible. ONLY USE ON A FLAT SURFACE$
MOVING THIS GRILL ON AN INCLINE WITH
A PALLET JACK IS NOT SAFE AND CAN CAUSE
INJURY OR DAMAGE TO PROPERTY OR
THE GRILL.
NEVER PUT THE INFIERNO ON ITS BACK,
FRONT OR SIDE! SIGNIFICANT DAMAGE TO
COMPONENTS OF THE GRILL CAN OCCUR.
USE GREAT CARE WHEN MOVING AN INFIERNO.
IF YOU HAVE ANY QUESTIONS OR CONCERNS
CONTACT GRILLWORKS AT (855) 434-3473
$BE SAFE!
CLEARANCES
The Infierno should be installed with 2” clearance to
noncombustible materials on the sides and back of the
unit. The front of the unit must have at least 36” clearance
to other equipment or walls for proper operation.
WARNING DO NOT PACK REQUIRED AIR SPACES
WITH INSULATION OR OTHER MATERIALS. The
grill is adequately insulated and the best outer insulator is
free air space.
Only install the Infierno on a non-combustible floor.
This non-combustible floor must extend at least 48” at
the front of the unit, 36” at the sides and 48” at the rear
(if the grill is installed exposed at the back). If installed
as a built-in (without legs) the base it is installed on must
also be non-combustible.
THE ENTIRE AREA OVER THE INFIERNO MUST
BE NONCOMBUSTIBLE EXTENDING 48” IN ALL
DIRECTIONS (IF NOT ENCLOSED) AND THE
GRILL MUST BE INSTALLED UNDER A SUITABLE
TYPE 1 SOLID FUEL HOOD SYSTEM.
ANY FACADE MATERIALS AROUND THE GRILL
MUST BE NON-COMBUSTIBLE.
IF THIS GRILL IS NOT PROPERLY INSTALLED A
FIRE MAY RESULT. A MAJOR CAUSE OF GRILL
RELATED FIRES IS A FAILURE TO MAINTAIN
REQUIRED CLEARANCES (AIR SPACES) TO
COMBUSTIBLE MATERIALS. IT IS CRITICAL
THAT THE INFIERNO GRILL BE INSTALLED BY
A QUALIFIED PROFESSIONAL AND ONLY IN
ACCORDANCE WITH THESE INSTRUCTIONS.
WARNING: DO NOT PACK AIR SPACES AROUND
GRILL WITH INSULATION
ALERT: Installation, operation and servicing of
this appliance can expose you to ceramic dust.