Page 12
3.2.4
Customer Supplied Installation Hardware
There are occasions where circumstances require that the customer provide the
installation hardware or that the flow meter must be installed through existing hardware.
In these cases, it is important to confirm that the installation hardware is suitable for use
with the flow meter provided by GREYLINE before it is installed. The installation must
allow for sufficient overhead clearance to fully extract the meter and a full 1” opening in
the pipe wall is required to clear the sensor head and allow for insertion. Make sure that
your valves and fittings are full port and at least 1” in actual internal diameter.
Installation hardware generally consists of three separate component parts:
And a full port
isolation valve.
CAUTION
Use stainless steel or brass nipple only.
!
CAUTION
In order to provide the flow meter with the correct stem length, GREYLINE must know the
over- all height of the installation hardware as measured from the outside wall of the pipe to
the top of the valve where the meter is installed.
!
CAUTION
Do not use threaded steel or slip PVC tees to provide the 1” opening in the pipe. Tees of this
type will cause significant errors in the flow measurement.
!
Some type of
threaded branch
outlet,
An
interconnecting
close nipple,
