SKU 66519
For technical questions, please call 1-800-444-3353.
Page 8
operating instructions
read the entire iMportant
saFety inForMation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
engine operation
inspect engine and equipment
looking for damaged, loose,
and missing parts before
set up and starting. if any
problems are found, do not use
equipment until fixed properly.
start procedure
Before starting the engine:
Follow the set up instruc-
a.
tions to prepare the equip-
ment. Follow all instructions
in the separate engine manu-
al provided with the engine.
inspect the equipment and
b.
engine.
Fill the engine with the
c.
proper amount and type of
fuel and oil. see checking
the Fuel level of the engine
Manual, page 9.
read the equipment opera-
d.
tion section that follows.
equipment operation
pre-operation procedures
Check and add hydraulic fluid to the
1.
Hydraulic Fluid Tank as needed (up
to 1.5 gallons). You can use 10 W
AW or Dextron® lll automatic trans-
mission fluid. You need to change the
fluid every 100 hours of usage.
Hydraulic Fluid
Fill Tube Cap
with Dip Stick
Hydraulic Fluid
Fill Tube
Figure 1
2.
To add hydraulic fluid:
Pull out the Hydraulic Fluid Fill Tube
a.
Cap.
Wipe off and reinsert fully.
b.
Pull out again and check the level on
c.
the attached dip stick.
Add hydraulic fluid if needed.
d.
Replace the Hydraulic Fluid Fill Tube
e.
Cap.
Inflate tires to 42 PSI.
3.
Remove Wheel Bearing Dust Proof
4.
Caps (15) and remove Bearings.
Completely pack with bearing grease.
Replace Bearings and Wheel Bear-
ing Covers. If you are not familiar
with this procedure, have a qualified
mechanic do it.
REV 09h
