Greyfox Cat 5 Installation Notes Download Page 1

P/N R1740                                                                                                                                                                           ©2004 

• This publication contains instructions for the installation of two separate parts: the Cat 5 Bullet & Infrared Camera, and the Cat 5

Camera Microphone.These parts are 

sold separately

under unique part numbers.

• The Cat 5 Bullet & Infrared Camera includes a specially engineered mounting wall plate that is designed to be installed in a

standard single gang box.

• The Cat 5 Camera can be installed

without

the Cat 5 Camera Microphone, but the Camera Microphone must be installed

with

the Camera mounting plate.

Before installing the Cat 5 Camera,please note:

Cat 5 Bullet & Infrared Camera (with optional microphone)

Installation Notes

1. Installing the Cat 5 Camera (with included mounting wall plate)

Rough-In

• The rough-in for this product is the same regardless if the microphone is installed or not.The

rough-in would consist of simply running a single Cat 5 line to a mounted single gang box in the
location of your choice.

Indoor Installation

• 

Install the Cat 5 Camera mounting hardware on to the Cat 5 Camera Mounting Wall Plate.
Firmly screw in the mounting post (included with the camera) to the post mounting hole
(Figure 1) on the front of the plate.

• Mount the Cat 5 Camera to the mounting hardware.
• Plug the RJ-45 connector from the camera into the RJ-45 jack which is labeled “INPUT FROM

CAMERA” and is located on the rear of the mounting wall plate (Figure 2).

• Plug the roughed in Cat 5 line from the Cat 5 Camera Module (in the enclosure) into the RJ-45

jack which is labeled “OUTPUT TO CAMERA MODULE” and is located on the rear of the
mounting wall plate (Figure 2).

• Install the mounting wall plate on the single gang box in the proper direction (use the directional

arrow on the back of the plate that is marked “UP” as a guide). Be sure to route the camera Cat
5 cord through the opening in the bottom of the mounting wall plate and tuck
any excess Cat 5 cord into the single gang box behind the wall plate.

Outdoor Installation

Follow the Indoor Installation instructions (above) and follow this additional information:
• Use a standard single gang box that is labeled “Suitable for Wet Locations”.
• Install the included rubber gasket on the rear of the mounting wall plate and make sure it creates

a tight seal between the mounting wall plate and the gang box.The use of additional weatherproofing such as a silicon based caulk
may be desirable if direct exposure to moisture is likely. If a caulk is used then be sure not to caulk the bottom edge of the
mounting wall plate to allow moisture to escape.

• Ensure that the sealing cap is in place (Figure 2).

Post Mounting 

Hole

Microphone

Screen

Figure 1

Sealing

Cap

INPUT FROM

CAMERA

Figure 2

OUTPUT TO

CAMERA MODULE

2. Installing the Cat 5 Camera Microphone 

(intended for indoor use only)

• Remove the sealing cap from the rear of the mounting wall plate (Figure 3).
• Carefully attach the Cat 5 Camera Microphone circuit board to the mounting wall plate circuit board.The pins on the Cat 5

Camera Microphone circuit board must be aligned with and plugged into the pin socket labeled “JP1” on the mounting wall plate
circuit board (Figure 4).

• Secure the Cat 5 Camera Microphone circuit board in place with the included screw (Figure 5).

Figure 3

Figure 4

Figure 5

Sealing

Cap

JP1 Pin Socket

Cat 5 Camera

Microphone Circuit

Board

Complete 

Assembly

Reviews: