GREMO 1050F4, Instruction Manual, Page: 125 / 198

Gremo1050F4 Instruction manual 6 Driving instructions
6.4 Brake test
NOTICE
Perform a brake test! See 6.4 Brake test , page 121.
When this has been done the machine is ready for work.
6.3.1 If the machine doesn’t start
Check that:
• the two emergency stop buttons are pulled out (both
inside the cab and outside).
• the main power switch is activated
• the batteries maintain the correct voltage.
• there is fuel in the fuel tanks.
• there are no active error codes.
• all fuses are intact.
Contact a service dealer if none of the above solves the
issue.
6.4 Brake test
Perform a brake test as follows:
1. Select driving direction and switch to 1st gear.
2. Press the foot brake pedal, see 4.2 Functions at the
steering wheel panel , page 54.
3. Raise the revs to ca. 1500 rpm.
4. The machine should now stand motionless or ‘creep’
forward very slowly, and you should sense a distinct
brake effect. Otherwise, please contact an authorised
service dealer or Gremo AB.
5. Checking the parking brake, see 2.9 Inspection of
parking brake , page 20.
121