H68.0.02.6C-04
Operating Manual GMK 210
page 3 of 20
_____________________________________________________
_____________________________________________________________________________
1 Intended Use
The device is designed for measurements of moisture (%u) and water content (%w) of materials
with flat surface and a thickness of at least 10mm.
In addition, it is possible to find moist spots very quickly and comfortably
by means of the “detector
mode”, the display value here is relative [digit].
The measurement takes place at an insulated measuring spot at the rear side of the device.
The GMK 110 is particularly suited for moisture measurements in the following materials:
wood
GRP
The GMK 110 is especially designed to meet the needs of moisture ratings of boats, camper vans
and caravans.
For use at construction site we recommend the GMK 100 (wood, floor screed and plaster
characteristics, CM-humidity)
The safety requirements (see below) have to be observed.
The device must be used only according to its intended purpose and under suitable conditions.
Use the device carefully and according to its technical data (do not throw
it, strike it, …)
Protect the device from dirt.
2 General Note
Read this document carefully and get used to the operation of the device before you use it. Keep
this document within easy reach near the device for consulting in case of doubt.
2.1 Safety signs and symbols
Warnings are labeled in this document with the followings signs:
Caution!
This symbol warns of imminent danger, death, serious
injuries and significant damage to property at non-observance.
Attention!
This symbol warns of possible dangers or dangerous
situations which can provoke damage to the device or
environment at non-observance.
Note!
This symbol point out processes which can indirectly
influence operation or provoke unforeseen reactions at non-
observance
.
