GREER COMPANY
Crane Systems
THE BA-
151
0
™
ANGLE IN
DICAT
OR (METER)
The BA-
1510™ Angle Indicator (meter) is used during setup and operation of the
crane to display the crane boom angle and to set and display crane boom minimum
and maximum angle limits. The System provides visual and audible warning alerts if
the set limit(s) are exceeded. Motion cuts (halting of crane hoist up, extend out, and
boom down movements) are available as an additional option, if desired. (Refer to
MOTION CUTS, page 7.)
SETTING AN ANGLE LIMIT
Position the crane boom at the desired limit.
Refer to the illustration on the opposite page while following the steps below.
1.
PRESS SET MIN
OR
SET MAX.
2.
PRESS
THE
UP
or
DOWN ARROW
IN THE CENTER OF THE METER TO
ADJUST THE LIMIT.
3.
PRESS ENTER.
NOTE
: The alarm(s) will activate until the boom is withdrawn from the SET
limit SHOWN on the display.
REMOVING AN ANGLE LIMIT
1.
PRESS SET MIN
OR
SET MAX.
2.
PRESS CANCEL
NOTE:
The limit will be replaced with a dashed
– – – – – line.
