BATTERY CHARGER
4
NOTE:
When the red indictor flickers, pull out the battery from the charger and insert again within 2
hours. If the indictor shows charging, that means the battery is good. After 2 hours, please pull out
the battery and also pull out the AC power plug of the charger for 1 miniute, and then insert the
AC power plug and the battery again. If the indictor shows charging, that means the battery is good.
If not, the battery needs to be changed.
N O T E
:
The battery is not shipped fully charged. It is recommended to fully charge before
use to ensure that maximum run time can be achieved. This lithium-ion battery will not
develop a memory and may be charged at any time.
1. Plug the charger into an AC power outlet.
2. Insert the battery pack (1) into the charger (2).
SPECIFICATIONS
CHARGING PROCEDURE
Input: 100-240V AC 50-60Hz
，
1.5A Max
40V charger: 29482
Output: 40V DC 2A
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
DEFECTIVE BATTERY:
(REMOVE AND REPLACE WITH
NEW BATTERY IF THIS OCCURS)
NO BATTERY PRESENT
RED
RED
GREEN
ORANGE
OFF
RED
RED
RED
RED
RED
BLINKING
3
1
2
This is a diagnostic charger. The Charger LED Lights (3) will illuminate in specific order to
communicate the current battery status. They are as follows:
False Defect Note:
When the battery is inserted into the charger, and the status
LED flashes, remove the battery from the charger for 1
minute, then reinsert. If the status LED indicates normal than
the battery pack is good. If the status LED is still blinking,
remove the battery pack and unplug the charger. Wait 1
minute and plug the charger back in and reinsert the battery
pack. If the status LED indicates normal than the battery
pack is good. If the status LED is still blinking then the
battery pack is defective and needs to be replaced.
Summary of Contents for 29462
Page 1: ......
