7.9
REMOVE THE BATTERY PACK
1. Open the battery door (20).
2. Remove the safety key (22).
3. Push and hold the battery release button (21).
4. Remove the battery pack from the machine.
8
OPERATION
WARNING
Wear eye protection during operation.
8.1
START THE MACHINE
TURBO
TURBO
1
29
23
2
2
1. Make sure safety key is inserted into slot.
2. Push and hold the start button (1).
3. While you hold the start button (1), grab the start handles
(2) in the direction of the handle bar.
4. Once the machine has started, you can release the start
button (1).
5. Press the Turbo button (29) to speed up to 3,200 RPM.
Battery capacity indicator (23)
Lights
Capacity
4 Green
Lights
The battery is above 80% capacity
3 Green
Lights
The battery is between 80% and 60% ca-
pacity
2 Green
Lights
The battery is at between 60% and 40% ca-
pacity
1 Green
Light
The battery is between 40% and 20% ca-
pacity
Lights go out The battery is less than 20% capacity and re-
quires charging immediately
8.2
STOP THE MACHINE
1. Release the start handle to stop the machine.
WARNING
Wait until the blade fully stops before you start the machine
again. Do not quickly turn the machine off and on.
WARNING
Always remove the safety key and battery pack after you
complete the work.
8.3
OPERATE THE SELF-PROPEL
DRIVE SYSTEM
1
2
3
24
TURBO
1. Start the machine.
2. While you hold the start handles (2), grab either of the
drive levers (3) and pull towards the handle bar.
3. Hold the start handles and the drive levers at the same
time.
4. Release either set of start handle (2) and drive lever (3)
from the same side.
5. Adjust the speed control (24) with your free hand.
• Slide the speed control button in the direction of the
Rabbit Symbol to increase the speed.
• Pull the speed control button in the direction of the
Turtle Symbol to decrease the speed.
6. Release the drive levers to close the self-propel system.
To engage the self-propel drive system while the mower is
not running:
• Press and hold the start button (1), then pull up on the
drive lever (3).
OR
• Pull up on the drive lever (3), then press the start button
(1).
11
English
EN
