ASSEMBLY
12
INSTALLING THE UPPER SHAFT TO THE LOWER SHAFT
(See
Figure 4.
)
W A R N I N G
Never install, remove, or adjust any attachment while the string trimmer is running. Failure to stop
the motor can cause serious personal injury.
The attachment connects to the power head by means of a coupler device.
1.
Set the unit on a flat, level surface.
2. Loosen the knob (1) on the coupler (5).
3. Push in the release button (2) located on the lower shaft (3). Align the release button with
the positioning hole (4) and slide the two shafts together. Rotate the lower shaft until the
button locks into the positioning hole.
1
5
4
2
3
Fig. 4.1
2
NOTE
: If the button does not release completely in the positioning hole, the shafts are not locked
into place. Slightly rotate from side to side until the button is locked into place.
4. Tighten the knob securely.
Fig. 4.2
LOOSE
TIGHTEN
1
5