7
4
Display 3
Hold
button shortly in display 2 to enter display 3. In the
riding condition, five seconds later, a single maximum speed (MXS)
display automatically returns to the real riding speed (KM/H).
5
In display 3, hold
button shortly (SW) and the display will
re-enter display 1.
6
Press and Hold
button to turn off the display and the power
supply of controller.
7.
Automatically prompt interface
7.1 Error Code Display Error Code Definition
01
＿
info Throttle Abnormality
03
＿
info Motor hall signal Abnormality
04
＿
info Torque sensor signal Abnormality
05
＿
info Axis speed sensor Abnormality (only applied to
torque sensor)
06
＿
info Motor or controller has short circuit Abnormality
Electronic control system failure will display (flashing) fault code. Once the fault was removed,
it automatically exits from the fault code display interface.
General Project Setting
1. Set maximum riding speed
After power on for 5 seconds, hold
and
button at the
same time, maximum riding speed KM/H and MXS flash, hold
or
button shortly to set the maximum riding speed (default 25KM/H).
Hold
button shortly and go to the next parameter settings.
2.
Wheel diameter setting
The wheel diameter will be set after finishing setting the
maximum riding speed, wheel diameter specifications flashes. Hold
or
button shortly to set the specifications of wheel diameter.
Select the range 6,8,10,12,14,16,18,20,22, 24,26,700c and 28 inches.
Hold
button shortly and go to the next parameter settings.
3. Set the metric units
