GreenTec HXF 2800, Handbook

Page: 9 / 27

HXF 2800 / 2802 AHS
9
Factors that affect stability

Centre of gravity of the tractor/machine combination.

Geometric conditions, e.g. position of the cutting head and ballast.

Weight, track width and wheelbase of the tractor.

Acceleration, braking, turning and the relative position of the cutting head during
these operations.

Ground conditions, e.g. slope, grip, load capability of the soil/surface.

Rigidity of implement mounting.
Suggestions to increase stability

Increasing rear wheel track; a vehicle with a wider wheel track is more stable.

Ballasting the wheel; it is preferable to use external weights but liquid can be
added to around 75% of the tyre volume – water with anti-freeze or the heavier
Calcium Chloride alternative can be used.

Addition of weights – care should be taken in selecting the location of the
weights to ensure they are added to a position that offers the greatest
advantage.

Front axle locking (check with tractor manufacturer).
NOTE: The advice above is offered as a guide for stability only and is not a guide to vehicle strength. It
is recommended that you consult your vehicle manufacturer or local dealer to obtain specific advice on
this subject, additionally advice should be sought from a tyre specialist with regard to tyre pressures
and ratings suitable for the type and nature of the machine you intend to fit.
Attachment of the machine must be performed in a safe location on a firm
level site.
Care should be adopted at all times when handling or manoeuvring the machine during the
attachment procedure; ensure all persons remain clear of the cutting blades which possess
the potential to cause injury even when stationary. For reasons of safety the blade guard
should be fitted to machine at all times and only removed for machine operation.