GreenTec HL 150, Handbook

Page: 20 / 31

Cuttterbar 150-180-210-240
When adapting the hedge trimmer to the tractor/vehicle, it is an advantage to use the profile
bars and/or the Ripp bolts (please refer to the spare parts list, pos. 1, 26). These fixing
devices facilitate a fast and problem-free replacement of defective parts whenever required.
4.5 Mounting on to tractor/vehicle
It is essential that you ensure that there are no people between the tractor/vehicle and the
trimmer during the mounting process.
Furthermore, you need to ensure that the hydraulic hoses are not positioned between the
tractor/vehicle and the trimmer in such a way that they could be squeezed or cut.
Place or hang the hydraulic hoses where directed by the manufacturer or where most
suitable.
Please refer to the operating instructions for the arm system.
Switch off the engine and ensure that the hydraulic system is de-pressurised before you
undertake any work on the vehicle or the HL hedge trimmer.
Remove the ignition key and secure the vehicle against accidental start and against rolling.
Do not ever walk or stand under a suspended load. Support and secure first the trimmer
and/or the arm system.
The fixing on to
the arm system will be described in the manufacturer’s operating instructions
relating to the arm system in question.
It is necessary to ensure that the hydraulic hoses are not positioned in such a way that they
are squeezed or risk snapping, as it will damage the hoses. Check the run of the hoses to
avoid the risk of damage.
Connect the two hydraulic hoses (from the hydraulic engine of the HL Cutterbar to the
tractor/vehicle)
in accordance with the particular manufacturer’s operating instructions.
The angle setting and/or the tilt of the hedge trimmer
will be described in the manufacturer’s
operating instructions for the arm system.
During this operation, ensure that there are
no people within the swing radius or working
area of the machinery.
During mechanical setting: the engine must be switched off and the machinery must be
secured (de-pressurised hydraulic system) before it is safe to carry out any work on the
machinery.
Setting: Follow the operating instructions for the arm system.
Warning: Be aware of the danger of sharp elements and of crushing