09
GREENIS
POWER BLENDER
GREENIS
POWER BLENDER 10
It is essential to tap SAVE “ ” button to save current step when programming each step.
If a program is merely 1 step,tapping COMPLETE “ ” will save the program eliminating the use of
SAVE” ” button.
A recipe that has been validly programmed will replace previous DIY program.
The machine may beep to indicate failure if any programming goes wrong. Such failure does not affect
or replace existing recipe program.
To ensure its long service life, the machine is preset at the workload of no more than 30 minutes working
continuously.
The machine will verify the duration of new program is no longer than 15 minutes. Otherwise program-
ming fails whilst the machine beeps twice to indicate failure.
A recipe program is composed of 18 steps at most. The display will show “FULL” to indicate the full limit
for steps.(The 18th step is still programmable but adding extra step is impossible)
For easier use,the 1st step is forbidden to be at speed “0”. (A failure to set speed other than “0” will
disable 1st step to be saved.)
Default recipe for DIY button is ICE CRUSH
If the last step fails to be saved without tapping SAVE “ ” button when programming multiple steps,
the program will only include previous steps excluding the last step after tapping COMPLETE “ ”.
Under DIY editing mode a continuous no-operation for 30 seconds will dim the display. A continuous
no-operation for 3 minutes will exit DIY editing mode. The steps that have been programmed will not be
saved.
Under DIY editing mode removing the jar will turn off the machine meanwhile exiting editing mode.
A valid DIY program will be stored into memory of the machine and last for 20 years whether machine
is connected to power or not.
Repeatable read-write cycles for DIY programming are 100,000 times.
PRECAUTIONS ON PROGRAMMING
STEPS OF RECIPE:
Start (tap to run DIY program cycle)
Cancel (exit DIY editing mode)
Rotate to set speed
Press dial to switch
to time setting
Press and hold to enter editing mode
Save entire program
DEFINITIONS OF BUTTONS UNDER
DIY EDITING MODE
HOW TO SELF-PROGRAM A DIY RECIPE:
A recipe program is normally composed of several steps to which individual speed and time is corre-
sponded.
Tap and hold DIY button for 3 seconds to enter editing mode whilst the display shows “ DIY ” . To edit
1st step ( while display shows “ S1 ” ), rotate the speed control dial to select desired speed.Press the dial
once to switch to time setting mode. And rotate the dial to set desired time. Tap “ ” button to save
the 1st step whilst display shows “ S. 01 ” to indicate success of step 1 being programmed. Moving to the
following steps, such operation method applies to every step of the way. Each step ( S1,S2,S3... ) must be
saved by tapping “ ” button. The recipe program is composed of no more than 18 steps.
After all steps are programmed into DIY button, tap COMPLETE “ ” to save the entire program.
Then the machine will stand by with DIY cycle automatically selected. Tap power button to run the cycle
which has been programmed.
Ice cream
