p r i d e o f t h e p a c i f i c S e r i e S c U r V e d M o d e L • G r e e n h o U S e i n S t r U c t i o n S
– 26 –
(Refer to the drawing.)
Take the door and set it inside the doorframe. Lift it up as high as possible
on the hinge side and put the screws through the existing holes in the doorframe.
Now the door will
hang by itself.
Remove the plastic clip from the “Z” bar and put one screw into the doorframe to hold the “Z”
bar. Open the door, take off the clips and put back the screws. Close the door and check that it is
square. If the frame and the door are square,
then fasten the “Z” bar to the frame. If not,
move the “Z” bar up or down to square it. If
this is not enough, loosen the bolts in the top
plates and move the frame to make it square.
When it is in place, tighten all the bolts.
Next install the door handle (see the
instructions inside the box). To install the
door catch angle, slide in two bolts into the
back of the door frame. Bolt on a small angle
(provided with the door handle). Face the angle
towards the door, line it up with the center of the door handle, and then tighten the two bolts
(see
picture to the right)
. Take the door catch out of the door handle box and screw it on. Close the door
and adjust the door sweep at the bottom of the door to eliminate potential gaps.
NOTE:
There are two types of manufactured doors. The door catch angle on the white door may have to be
turned the opposite way as shown on picture
1
.
Run a bead of silicone under the angle above the door and against the doorframe. Also
silicone the “ ” on the glass beside the door to ensure an airtight seal.
Z Bar
Z Bar
Door Installation
1
Door Catch Angle
