TERMINAL MODE
Terminal mode is accessed via the MicroUSB connector on the Arduino that is on the bottom
of the Spankulator. It is always available and cannot be turned on or off.
Use a terminal emulation program like PuTTY that has VT-100 mode. The Spankulator is set to
run at 115200 baud but will adapt to the PuTTY settings.
Please refer to the table of commands that follows this section.
TERMINAL EXAMPLE SCREEN
Figure 10 - Terminal Interface Screen
Important!
Only connect USB to a powered-up system. Otherwise, the 5V power from the USB
will try to power the entire rack. And that
’
s not really good. So, please disconnect the USB
cable before you turn off the power!