Remote Control System
A toggle switch is located on the front drivers side of the Haulit manufactured in 2020,
for older models the toggle switch is located inside the front of the trailer in a grey box.
Switch the toggle switch on. On the remote, hit the start button. This connects the
remote inside the trailer. On the remote, you have an up and down, and in and out
(which is labeled West and East) To turn it back off, hit the Stop. This disconnects
from the grey remote. Then, turn off the toggle switch.
When you turn on the toggle switch, the voltmeter adjacent to the toggle switch
illuminates -indicating the voltage of the battery. If this is not at full charge, you will
need to charge the battery to full charge prior to each use.
Loading The Haulit
Prior to loading your first pallet, ensure the push- off bar is just below the deck. Use
the remote to push the pallet far enough forward to position the second pallet making
sure the bar is just below the deck. When loading the trailer make sure you position
the weight far enough forward to give you adequate tongue weight. This will eliminate
trailer sway. Make sure you secure your load using tie downs or the optional built in
tarping system. You can now close the back safety doors and insert the safety pin.
You’re ready to go.
Unloading the Haulit
Once you’ve reached your delivery location, untarp or unstrap your load. Open the rear
trailer doors. Using the hand held remote, positions the back pallet towards the rear of
the trailer. Use the up button on the hand held remote to raise the cargo pan until the
skid plates touch the ground. Once the pallet comes in contact with the ground, do not
use the push off system to completely unload the pallet. Allow the pallet to come into
contact with the ground, then pull the truck slowly forward and out from under the
pallet. Once you have pulled out from the first pallet, you are now ready to position
the next pallet until it touches the ground. Once it touches, pull the truck slowly
forward and out from under the pallet. Repeat this process for 2, 3, and 4 pallets. Once
you have unloaded your load, lower the front of the cargo pan, close the doors, and
you're ready to make your next delivery. At the end of the day, make sure you turn off
your remote, turn off the toggle.
A 110 charging is located in the box on the front driver side of the trailer. It is a good
practice to charge the battery when the Haulit is not in use.
