g
Green-GO Wireless Quick Start Guide
www.greengodigitial.com
Version 2.2
To clear any previously paired connections from the antenna, press and hold the red button until the
LED begins to flash red quickly. The antenna will now begin to remove any previously paired devices,
before returning to it’s previous state (either red/green blink if no other device on the system is found
with the same configuration, or green blink if another device is found on the system with the same
configuration.
Defining Channels Names and User Groups
Selecting the User:
o
To select the user of the belt-pack, enter the menu using the rotary encoder and selecting
Setup. Scroll down to Select User, and press the rotary encoder. Scroll to your desired user,
and depress encoder
Channel Assignment:
o
To assign Users or Groups to any of your 32 channels, enter the menu using the rotary
encoder and selecting Setup.
o
Scroll down to Channel Assignment, and press the rotary encoder. You will see a list of 32
channels. Each of these channels can be assigned to either a User or Group.
o
To assign a channel, scroll to the desired channel number, and press the encoder. Scroll to ID
and press the encoder. From here you can choose either User or Group. Selecting either of
these options, will present a list of either Users or Groups, which can be assigned to that
Channel on your belt-pack.
Troubleshooting
There is no signal or poor signal level to the
belt-pack
-
Check Pairing with Antenna
-
Check you are within range (300 metres
maximum with clean line of sight)
-
Ensure that the antenna is vertically
orientated
My voice is distorted or muffled
-
Check the sensitivity of the microphone
in the audio section of the menu
The antenna is not sending a signal
-
Check that the LED is not blinking red
and green. This mean that there is no
other device on the system or that the
antenna is not configured to the network
configuration.
The device will not connect to the network
-
You may not be using the same
configuration as the existing network.
Use the menu option to clone the
existing network configuration.
