Green Gear GE-2000, Operating And Maintenance Original Instructions

Page: 17 / 222

GENERATOR MANUAL
17
PRE-OPERATION CHECKS
How to attach the handles:
Attach 2 x Handles and Handle
brackets using the black 40mm bolts
and nuts as per picture
How to attach the wheels:
Attach each wheel to the frame using
1 x 100mm bolt and nut
How to attach the feet:
Attach feet mountings to bottom of
frame and bracket using silver 30mm
and 20 mm bolts and nuts
4.2 REMOVE TRANSPORTATION BOLT
NOTE: This unit is shipped with a transportation bolt, before starting the generator you must remove the
center transportation bolt and rubber sleeve (see pictures below) from the engine mounting bracket.
Failure to do so could result in serious damage to the generator during operation.
4.3 CHECK ENGINE OIL
NOTE: this unit is shipped without oil in the crankcase. In order to avoid damage to the unit, put oil in the
crankcase before you attempt to start the unit for the first time.
Before checking or refilling oil, be sure generator is on a level surface with engine stopped.
Remove oil filler cap and check the engine oil level.
If oil level is below the lower level line, refill with suitable oil (see oil table) to upper level line.
Change oil if contaminated see chapter 7.1.