35
www.bikefriday.com
800-777-0258 • +1-541-687-0487
Packing: PakiT in TravelCase
Fig. 50
Fig. 51
Fig. 52
Fig. 53
Placing the PakiT into a
TravelCase
Place the main frame protec-
tor (half of a crush protector)
in the open end of the rear
end half.
[Figure 50]
Place the front end of the
bike, with the head tube in
the Northeast corner. Allow
the handlebars to dangle out-
side, to the right of the case.
[Figure 51]
Place the rear end of the
bike in with the rear derail-
leur at the Southwest corner
of the case. The rear end will
fit somewhat diagonally into
the case. Please make sure
the non drive crank arm is not
striking the fork. Point it to-
ward the headset. [Figure 52]
Place the handlebars in the
center of the case, bars to-
ward the North, stem riser
pointing South. [Figure 53]
Mechanics Tip: If you need
more slack to arrange the
handlebars, you can increase
slack by carefully pulling the
cable housing through the
housing loops on the frame.
Tip # 2: If needed, you can
loosen the handlebar clamp
bolt to allow you to rotate
the bars to provide more flex-
ibility in the fit of the bar
controls in the case.
