68
Technical Information
Service Manual
I FEEL Function
Press "▲" and "MODE" buttons simultaneously to start I FEEL
function and " " will be displayed on the remote controller.
After this function is set, the remote controller will send the
detected ambient temperature to the controller and the unit will
automatically adjust the indoor temperature according to the
detected temperature. Press this two buttons simultaneously
again to close I FEEL function and " " will disappear.
Please put the remote controller near user when this function
is set. Do not put the remote controller near the object of high
temperature or low temperature in order to avoid detecting
inaccurate ambient temperature. When I FEEL function is turned
on, the remote controller should be put within the area where
indoor unit can receive the signal sent by the remote controller.
Replacement of batteries in remote controller
battery
remove
reinstall
Cover of battery box
signal sender
1. Press the back side of remote controller marked with " ", as
shown in the fig, and then push out the cover of battery box along
the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the
position of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
Notice
：
● During operation, point the remote control signal sender at
the receiving window on indoor unit.
● The distance between signal sender and receiving window
should be no more than 8m, and there should be no obstacles
between them.
● Signal may be interfered easily in the room where there
is fluorescent lamp or wireless telephone; remote controller
should be close to indoor unit during operation.
● Replace new batteries of the same model when
replacement is required.
● When you don't use remote controller for a long time,
please take out the batteries.
● If the display on remote controller is fuzzy or there's no
display, please replace batteries.
