Wired Remote Controller
XE71
(XE71-44/G)
3
2.2 Function of the
Touch Pad
Buttons
Table 2
No.
Name
Function
1
Enter/Cancel
Function selection and cancellation.
2
▲
①
Running temperature setting of the indoor unit, range:61~86°F(16~30
℃
)
.
②
Timer setting, range:0.5-24 hr.
6
▼
3
Fan
Setting of
the high/middle/low/auto fan speed
s
.
4
Mode
Setting the Cooling/Heating/Fan/Dry/Auto mode of the indoor unit.
5
Function
Switchover
to the Turbo/Save/E-heater/Blow etc.
function
s.
7
Timer
Timer setting.
8
On/Off
Turn
indoor unit
on/off.
4+2
▲+Mode
Press
for 5
s
ecs when
unit
is off
to
Enter/Cancel the Memory function
(If
memory is set, indoor unit will
re
turn to
the
last setting upon power
failure
. If not, the indoor unit is defaulted to
"
off
"
after power recovery.
"
Memory off
"
is
the
default
setting at time of delivery
).
3
+6
Fan+▼
By pressing the
se
at the same time
when unit is
off will be
displayed
on the wired remote controller
.
2
+6
▲+▼
Upon startup of the unit
, if there are no problems
or
if the unit is off,
press
both
at the same time for 5s to enter the lock
mode where no
buttons will
won’t respond
when pressed
. Repress
both
for 5s to
cancel
this
operation.
4+6
Mode+▼
While
"
OFF
"
the Celsius and Fahrenheit scales can be switched by
5+7
FTimer
①
Indoor ambient temperature is sensed by the return air temperature
sensor ( 01 displayed on the timer area).
②
Indoor ambient temperature is sensed by the wired controller (02
displayed on the timer area).
③
The return air temperature sensor is selected under the cooling, dry, or
fan mode; while the wired controller temperature sensor is selected under
the heating or auto mode. (03 is displayed on the timer area).
④
The wired controller temperature sensor is selected under the cooling,
dry, or fan mode; while the return air temperature sensor is selected under
the heating mode. (04 is displayed on the timer display area).
5+7
FTimer
While "
OFF
"
, it is
possible
to go to the commissioning status by
pressing “Function” and “Timer” for five seconds. Press “Mode” button
until “01” icon is shown
in
the temperature display area. Press “
▲
” and “
▼
”
t
o select the following
available
options
:
①
Three low levels (01) ;
②
Three
high levels (02).
While "OFF", it's possible to go into the commissioning status by pressing
“Function” and “Timer for five seconds and leaving “00” in the temperature
display area. Then, pressing “Mode”, adjust the options in the timer area
by pressing “▲” and “▼”to select the following options:
