12
Technical Information
Service Manual
1. On/Off button
6. Sleep button
8. Turbo button
7. Temp button
2. Mode button
3. Fan button
Press this button to turn on the unit. Press this button again to turn off the unit.
Under Cool, Heat or Dry mode, press this button to turn on Sleep function.
Press this button again to cancel Sleep function. Under Fan and Auto modes, this function is unavailable.
Press this button to activate / deactivate the Turbo function.
Press this button, you can see indoor set temperature, indoor ambient temperatureon indoor unit’s display. The setting on remote controller
is selected circularly as below:
10. Timer button
● Under ON status, press this button to set timer OFF; Under OFF status, press this button to set timer ON.
● Press this button once and the characters of HOUR ON (OFF) will flash to be displayed. Meanwhile, press "▲" button or " " button to
adjust timer setting (time will change quickly if holding "▲" or " " button). Time setting range is 0.5~24hours.
Press this button again to confirm timer setting and the characters of HOUR ON (OFF)will stop flashing.
If the characters are flashing but you haven’t press timer button,timer setting status will be quit after 5s.If timer is confirmer, press this button
again to cancel timer.
4. ▲/
▲
button
11. X-Fan button
12. Light button
● Press ▲ / button to increase/decreaseset temperature. In AUTO mode, set temperature is not adjustable.
● When setting Timer On or Timer Off, press "▲" or " " button to adjust the time.
Press this button in COOL or DRY mode to turn on X-fan function.
When this function is started up, indoor fan will still operate at low fan speed for a while after turning off the unit by remote controller.
Press this button to turn on the display's light and press this button again to turn off the display's light.
Note:
Outdoor temperature display is not available for some models. At that time, indoor unit receives " " signal, while it displays indoor set
temperature.
5. Swing button
Press this button to set up & down swing angle.
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, , to
, then back to Auto.
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL, DRY, FAN, and HEAT *, as the following:
Note: Only for models with heating function.
AUTO
COOL
DRY
FAN
HEAT
*
no display
9.
button
Press this button to achieve the on and off of healthy and scavenging functions in operation status. Press this button for the first time to start
scavenging function; LCD displays " ". Press the button for the second time to start healthy and scavenging functions simultaneously;
LCD displays " " and " " . Press this button for the third time to quit healthy and scavenging functions simultaneously. Press the button
for the fourth t ime to start healthy function; LCD display " " .
Press this button again to repeat the operation above.
● This function is only available for some models.
▲
▲
▲
▲
