13
Introduction for buttons on remote controller
Note:
Ɣ
Under on and off status, you can set TIMER OFF or TIMER ON simultaneously.
Ɣ
Before setting TIMER ON or TIMER OFF, please adjust the clock time.
Ɣ
After starting up TIMER ON or TIMER OFF, set the constant circulating valid.
After that, air conditioner will be turned on or turned off according to setting time.
ON/OFF button has no effect on setting. If you don’t need this function, please
use remote controller to cancel it.
the remote controller near the object of high temperature or low temperature in
order to avoid detecting inaccurate ambient temperature. When I FEEL function
is turned on, the remote controller should be put within the area where indoor
unit can receive the signal sent by the remote controller.
Ɣ
TIMER ON button
"TIMER ON" button can set the time for timer on. After pressing this button, " "
LFRQGLVDSSHDUVDQGWKHZRUG21RQUHPRWHFRQWUROOHUEOLQNV3UHVVŸRU
Ÿ
" " button to adjust TIMER ON setting.
$IWHUHDFKSUHVVLQJŸRUEXWWRQ
Ÿ
7,0(521VHWWLQJZLOOLQFUHDVHRUGHFUROGŸRUEXWWRQV
Ÿ
later, the time will change quickly until reaching your required time.
Press "TIMER ON" to confirm it. The word "ON" will stop blinking. " " icon
resumes displaying. Cancel TIMER ON: Under the condition that TIMER ON is
started up, press "TIMER ON" button to cancel it.
Ɣ
TIMER OFF button
"TIMER OFF" button can set the time for timer off. After pressing this button," "
icon disappears and the word "OFF" on
UHPRWHFRQWUROOHUEOLQNV3UHVVŸRU
Ÿ
" " button to adjust TIMER OFF setting.
$IWHUHDFKSUHVVLQJŸRUEXWWRQ
Ÿ
7,0(52))VHWWLQJZLOOLQFUHDVHRUGHFUROGŸRUEXWWRQV
Ÿ
later, the time will change quickly until reaching your required time.
Press "TIMER OFF" word "OFF" will stop blinking. " " icon resumes displaying.
Cancel TIMER OFF. Under the condition that TIMER OFF is started up, press
"TIMER OFF" button to cancel it.
10
TIMER ON / TIMER OFF button
11
CLOCK button
Press this button to set clock time. " " icon on remote controller will blink. Press
9
I FEEL button
Press this button to start I FEEL function and " " will be displayed on the remote
controller. After this function is set, the remote controller will send the detected
ambient temperature to the controller and the unit will automatically adjust the
indoor temperature according to the detected temperature. Press this button again
to close I FEEL function and " " will disappear.
Ɣ
Please put the remote controller near user when this function is set. Do not put
enquiry procedure, press "ON/OFF" button, "Mode" button, "Timer" button or "Sleep"
button, the sleep curve setting or enquiry status will quit similarly.
