Gree GWC24ACE-K6DNA1 A/I, Service Manual

Page: 34 / 132

31
Technical Information
Service Manual
When I FEEL function is turned on, the remote controller should be put within the area where indoor unit can receive the signal sent by the
remote controller.
● The function is only available for some mode
● Press this button, can select Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ) and cancel the Sleep, circulate between these, after electrified,
Sleep Cancel is defaulted.Sleep 1 is Sleep mode 1, in Cool modes; sleep status after run for one hour, the main unit setting temperature will
increase 1 , two hours, setting temperature increased 2 , then the unit will run at this setting temperature; In Heat mode: sleep status after run
for one hour, the setting temperature will decrease 1 , two hours, setting temperature will decrease 2 , then the unit will run at this setting
temperature.
● Sleep 2 is sleep mode 2, that is air conditioner will run according to the presetting a group of sleep temperature curve.
● Sleep 3-the sleep curve setting under Sleep mode by DIY;
(1)Under Sleep 3 mode, press “Turbo” button for a long time, remote controller enters into user individuation sleep setting status, at this time,
the time of remote controller will display “1hour”, the setting temperature “88” will display the corresponding temperature of last setting sleep
curve and blink (The first entering will display according to the initial curve setting value of original factory);
(2)Adjust "▲" and " "▲ button, could change the corresponding setting temperature, after adjusted, press “Turbo” button for confirmation;
(3) At this time, 1hour will be automatically increased at the timer postion on the remote control, (that are "2hours" or "3hours" or "8hours"),
the place of setting temperature "88"will display the corresponding temperature of last setting sleep curve and blink;
(4) Repeat the above step (2)~(3) operation, until 8 hours temperature setting finished, sleep,curve setting finished, at this time, the remote
controller will resume the original imer display; temperature display will resume to original setting temperature.
● Sleep3- the sleep curve setting under Sleep mode by DIY could be inquired: The user could accord to sleep curve setting method to inquire
the presetting sleep curve, enter into user individuation sleep setting status, but do not change the temperature,press “Turbo” button directly for
confirmation. Note: In the above presetting or enquiry procedure, if continuously within 10s, there is no button pressed, the sleep curve setting
within 10s, there is no button pressed, the sleep curve setting status will be automatically quit and resume to display the original displaying.
In the presetting or enquiry procedure, press "ON/OFF" button, "Mode" button, "Timer" button or "Sleep" button, the sleep curve setting or
enquiry status will quit similarly.
1 2 3