DC Inverter U-Match Series Cassette Type Unit
18
(2) Installing the Main Body Unit.
1) Install the hoisting stand on the hoisting screw by using nuts and
gaskets at both the upper and lower sides of the hoisting stand. To
prevent the gasket from breaking off, a gasket anchor board can be
helpful.
2) Install the paper template on the unit, and fix the drain pipe at the outlet
vent.
3) Adjust the unit to the best position.
4) Check if the unit is installed horizontally at four directions. If not, the
water pump and the float switch would function improperly and even
lead to water leakage.
5) Remove the gasket anchor board and tighten the nut remained.
6) Remove the paper template.
Summary of Contents for GUD100T/B-S
Page 66: ......
