Multi Variable Air Conditioners Console Type Indoor Unit
12
NOTES!
The power of every indoor unit should be unity power supply.
①
The power connection cord has been inserted on the mainboard through the piping hole of
the chassis. Please connect the power connection cord with the breaker. If the power cord is
not long enough, please prolong it with terminal block.
②
Reinstall the wiring cover on the original place and tighten the bolt.
③
Recover the surface panel.
CAUTION!
①
Do not use tapped wires, stranded wires, extension cords, or starburst connections, as they
may cause overheating, electrical shock, or fire.
②
Do not use locally purchased electrical parts inside the product (Do not branch the power for
the drain pump, etc, from the terminal block). Doing so may cause electric shock or fire.
Install the drainage pipe.
(1) For well draining, the drain hose should be placed at a downward slant.
(2) Do not wrench or bend the drain hose or flood its end by water.
(3) Wrap heat resistant material when connect the longer drainage tube though indoor.
Wrenched
Bent
Flooded
Install the connection pipes.
Connect the connect pipe with the two relative leading pipe, tie the nut on tie in of the connect
pipe tightly.
NOTES!
①
Be careful in bending the connection pipes, or you will damage the pipes.
②
If the tightening torque is too great in tightening the flare nut, leakage will happen.
2.5 Wiring Requirements
Model
Power Cord Size Air Switch Capacity(A)
Minimum Sectional
Area of Ground
Wire(mm
2
)
Minimum Sectional
Area of Power
Cord(mm
2
)
GMV-ND22C/A-T
GMV-ND28C/A-T
GMV-ND36C/A-T
GMV-ND45C/A-T
GMV-ND50C/A-T
220~240V ~ 50Hz
208~230V ~ 60Hz
6
1
1
Summary of Contents for GMV-ND22C/A-T
Page 30: ......
