Multi Variable Air Conditioners Wall Mounted Type Indoor Unit
13
(3) Install the panel.
As shown in Fig. 7.1.1, install the stands of both ends of the panel into the slot and put the middle
rotating shaft into the groove, then place the panel and clasp back along the arrow direction.
Fig. 7.1.1
7.2 Cleaning the Air Filters
Clean it once every 3 months; when the usage environment has lots of dust, it should be cleaned
more frequently.
(1) Take down the air filter.
As shown in Fig. 7.2.1, open the surface panel by holding the both ends of groove along the
arrow direction, and then take the air filter out downward.
(2) Clean the filter.
Use cleaner or water to wash the filter; if the filter is too dirty (like oil stain on it), warm water
(lower than 45°C(113°F)) with neutral detergent can be used, then dry it in the shade.
(1) Do not clean the filter by hot water higher than 45°C (113°F) for preventing fade or deformation.
(2) Do not burn it on fire or the filter would catches fire or deformation.
(3) Do not clean the filter by hot water higher than 45°C (113°F) for preventing fade or
deformation.
Do not burn it on fire or the filter would catches fire or deformation.
(4) Install air filter.
Install the air filter properly along the arrow direction, making the side marked “Front” facing
yourself and then place the panel back.
Fig. 7.2.1
7.3 Check before the Usage Season
(1) Check if there is blockage in the inlet or outlet vent of the air conditioner.
(2) Check if the earth wire is earthed reliably.
(3) Check if the batteries in the wireless remote controller have been replaced.
(4) Check if the air filter has been installed properly.
In order to start up the air conditioner smoothly after it has been turned off for a long time period,
energize the unit 8 hours before turning it on.
Summary of Contents for GMV-ND06G/B4B-T
Page 20: ......