FLOOR/CEILING B SERIES
OWNERS MANUAL - INDOOR UNIT
|
21
CARE AND CLEANING
WARNING
• Turn off the air conditioner and disconnect the
power before cleaning the air conditioner to avoid
electric shock.
• Do not wash the air conditioner with water to avoid
electric shock.
• Do not use volatile liquid to clean the air conditioner.
• Do not use liquid or corrosive detergent to clean the
appliance and do not splash water or other liquid
on it to avoid damaging the plastic components or
causing an electric shock.
Clean surface of indoor unit
Only a qualified service person is allowed to perform
maintenance.
Before accessing to terminal devices, all power supply
circuits must be disconnected.
Clean the filter and the outside panels with warm water,
and do not use excessive heat to dry.
NOTE
1
Do not operate the air conditioner with the filter
uninstalled, otherwise dust would come into the
unit.
2
Do not remove the air filter except for cleaning.
Unnecessary handling may damage the filter.
3
Do not clean the unit with gasolene, benzene, thinner,
polishing powder or liquid insecticide, otherwise it
would cause discoloration and deformation of the
unit.
4
Do not wet the indoor unit in case of electric shock
or fire hazard.
Increase the frequency of cleaning if the unit is
installed in a room where the air is extremely
contaminated. (As a yardstick for yourself, consider
cleaning the filter once a half year.)
If dirt becomes impossible to clean, change the air
filter.
How to Clean Filter
1. Open the air inlet grille
1
First remove the two buckles on the grille as shown
on the picture
2
Remove the screws under the buckles by a
screwdriver and then open the inlet grille.
2. Clean the filer screen
Clean the filer screen by a vacuum cleaner or
wash it by flashing water. If the oil stain on the filter
can not be removed or cleaned up, wash it by warm
water meld with the detergent. Dry the filer in the
shadow.
NOTE
• To avoid color fading or deformation, do not use
hot water.
• To avoid deformation or a fire hazard, do not use
excessive heat when drying the filter.
3. Disassemble the left and right side board
1
After the grille is removed, use a screwdriver to
remove the screws shown on the picture.
2
Push the side plate as per the arrowed
direction and take it down.
4. Disassemble the right side board
Follow the Step 3 to disassemble the right side board.
