Greatneck 80167, Owner'S Manual

Page: 13 / 21

ON-BOARD SCREWDRIVER BIT
STORAGE
Convenient on-board screwdriver bit
storage (1) is provided at the rear of the
drill housing (Fig. 3).
TORQUE ADJUSTMENT
Your drill is equipped with an adjustable
torque clutch for driving different types of
screws into different types of materials. The
proper setting depends upon the type of
material and size of screw being used.
Adjust the torque setting as follows:
1.
Identify the torque settings located on
the torque adjustment ring (1) (Fig. 4).
2.
Rotate adjustment ring to align the
correct torque setting number with the
torque indicator arrow (2). See chart
below for correct torque settings.

1–2 For driving small screws

3–4 For driving medium-sized
screws into soft materials

5–6 For driving screws into soft &
medium-density materials

7 For driving screws into
hardwood

8 For driving large screws

Use highest setting for drilling.
This position is marked with a
picture of a drill bit on the torque
adjustment ring.
FORWARD/REVERSE SWITCH
The forward/reverse switch (1) is
conveniently mounted above the trigger
switch (2) (Fig.5). To make the drill rotate
clockwise (for drilling) push the forward /
reverse switch to the left. To make the drill
rotate counter-clockwise for removing
screws, push the forward / reverse switch
to the right.
NOTES:
a) Never change position of the
forward/reverse switch while chuck is
turning.
b) The trigger switch will NOT function with
the forward/reverse switch in the middle
position.
TWO-SPEED GEARBOX
Set the speed control switch (1) to the
desired speed (Fig. 6). Slide the speed
control switch toward the rear of the drill for
low-speed operation. Slide the speed
control switch forward toward the front of
the drill for high-speed operation.
NOTES:
a) Use low-speed setting (position ) for
drilling large holes and for driving screws.
13
ASSEMBLY & OPERATION
Fig. 3
Fig. 4
Fig. 6
Fig. 5