9
ACCESSORIES &
CARTON CONTENTS
DRILL COMPONENTS
DESCRIPTION
QTY
Drill
1
Owner’s manual
1
AVAILABLE ACCESSORIES
WARNING:
Use only accessories
recommended for this drill. Follow
instructions that accompany
accessories. Use of improper
accessories may cause injury to the
operator or damage to the drill.
Do not use any accessory unless you have
completely read the instructions or Owner’s
Manual for that accessory.
Drill bits
Screwdriver bits
WARNING:
If any part is missing
or damaged, do not plug the drill into
the power source until the missing or
damaged part is replaced.
Carefully unpack the drill. Compare
contents against the “Drill Components”
chart below.
WARNING:
To avoid fire or toxic
reaction, never use gasoline, naphtha,
acetone, lacquer thinner or similar
highly volatile solvents to clean the tool.
FORWARD/REVERSE LEVER
The forward/reverse lever (1) is
conveniently mounted above the trigger
lever (2) (see Fig. 1). To make the drill
rotate clockwise (for drilling) push the
forward/reverse lever to the left. To make
the drill rotate counter-clockwise for
removing screws, push the forward/reverse
lever to the right.
NOTE: Never change position of the
forward/reverse lever while chuck is
turning.
TRIGGER SWITCH
This drill is equipped with a ON/OFF trigger
switch.
1. To start drill, gently squeeze the trigger
switch (1) (see Fig. 2).
2. To stop the drill, release the trigger
switch.
NOTE: Drilling for an extended period of
time may cause the drill motor to overheat.
If the drill motor gets hot, stop drilling and
allow to cool for at least 15 minutes.
CARTON CONTENTS
!
!
!
ASSEMBLY & OPERATION
Fig. 1