18
receiver. Make sure the controls are all centered and moving
the correct direction. If you have any question about the
direction the surfaces should move refer to the instructions on
page 20 of this manual. When you are satisfi ed that the radio
system is set up properly, place the receiver on the Velcro
®
.
Next you need to plug in all of the motor leads. Before doing
this remove the nut and washer from the motors. Plug the
right motor into the leads from the right speed control. Plug
the left motor into the remaining leads. Plug the “Y” connector
into the appropriate channel for your receiver. Arm the speed
control. Looking at the front of the motors, check to be sure
that the motors are both turning counter-clockwise. If they do
not turn counter clockwise unplug two of the three leads from
the motor and reverse them. This will change the direction of
the motor rotation. When both motors are turning the correct
direction disconnect the battery.
FINAL ASSEMBLY
❏
1. Install the drain plug into the bottom of the fuselage.
Use this plug to drain any water that might get into the fuse
during a fl ight.
❏
2. Install the water rudder onto the water rudder control
wire. Apply a couple of drops of thread locker to the set screw,
align the water rudder with the rudder and tighten the set
screw against the wire.
❏
3. Apply the self adhesive foam tape to the wing saddle.
This will prevent any water from getting into the fuselage.
❏
4. Locate the two 3/8" x 3/8" x 15/32" [10mm x 10mm x
12mm] wood blocks.
