
YP4425A
Operating Instructions
27
2018-07-30
401-805M
Raising Planter
1.
If the planter has hydraulic hitch, set the Lift/Hitch
switch
to LIFT.
If the planter has the standard 3-point hitch, this
switch has no function. The hydraulic circuit is always
in Lift (Raise/Lower) mode.
2.
Move the cab lever to Extend the circuit for Lift/Hitch.
Machine Damage Risk:
On tractors with electronic timer controls for hydraulic
circuits, lift timers must be set to no more than 2 seconds
longer than needed to fully raise planter.
Do Not Set for Continuous Mode.
For transport, maintenance or storage, install lift cylinder
locks. See “
Lowering Planter
1.
If lift cylinder locks are installed, first fully raise the
planter, and remove the locks. See “
2.
If equipped with hydraulic hitch, set the Lift/Hitch
switch
to LIFT. On 3-point hitch, this switch has no
function and the circuit is in Lift mode at all times.
3.
Move the cab lever to Retract the circuit for Lift/Hitch.
When fully lowered, return lever to neutral.
Machine Damage Risk (Hydraulic Hitch Only):
Never lower planter while fully folded, if it is equipped with
the hydraulic tongue hitch, or machine damage can occur
unless a special procedure is followed (see page 28). A planter
with a 3-point hitch may be lowered while folded.
Machine Damage Risk:
Never lower planter while partially unfolded (with either
hitch). Wing row units can strike main transport wheels.
1
Figure 24
CFM: Raising Planter
26113
Pinch/Crush Risk:
Keep all personnel clear of center section and seed cart while
raising tool bar. The wheels move inward.
Figure 25
CFM: Lowering Planter
26113
Crushing Risk:
Keep all personnel clear of center section and seed cart while
raising tool bar. The wheels move outward.