Great Plains
| 562-339Q | 05/05/2021
6
6539-6545UC
Introduction
Shipping
Refer to Figure 3 (Center Frame Shown)
The Ultra Chisel will be shipped partially assembled.
•
The Ultra Chisel will be shipped with shipping stands that
will not need to be returned to Great Plains.
•
Wings will be stacked and have the shank upright
assemblies already installed. The back row of shank
assemblies will not have the shanks or sweeps installed.
These will need to be installed into the uprights before
assembly is completed.
•
All hydraulics will be attached to the frame sections.
Hydraulic systems will need to be connected, at bulkhead
fitting brackets and charged and purged of any air.
•
Hydraulic cylinders may be only partially installed and
may need to be left unattached until after charging the
hydraulic system.
•
Shank mount upright assemblies will be attached to
frames in proper locations, but may need to have the
shanks and sweeps installed
•
Shank assemblies will be shipped in a box on a pallet.
•
Finishing attachments (if equipped), will be pre-
assembled and banded to a pallet. Some attachments will
need drag arm extensions. See parts manual for proper
identification.
Unloading
Be sure the truck is on level ground, preferably concrete.
Centering componets:
The Ultra Chisel is very heavy, be sure the machinery you are
using to unload the sections is rated for its share of the load. Be
sure and center fork truck or chains (overhead hoist) on
componets so they won’t slide and cause injury.
Unload Smaller Items First
Unloading the Ultra Chisel is a potentially dangerous
operation.
Place smaller components well out of the maneuvering
area needed for unloading the Ultra Chisel
Reduce risk and complications by first unloading:
6. finishing attachments
7. misc. boxes
8. gauge wheel assemblies
9. Place these components well out of the maneuvering area
needed for unloading the Ultra Chisel
10. Ultra Chisel (described in next section).
Figure 3
Ultra Chisel Shipping
43661
