GREAT PLAINS NTA3007HD, Operator'S Manual

Page: 41 / 178

NTA907HD and NTA3007HD Table of Contents Index Operating Instructions
Great Plains | 166-207M | 02/26/2019 Table of Contents Index 35
Folding: Summary of Steps
Follow the detailed instructions in step 1 through step 22
until this is a familiar operation.

Check marker, auger and ladder stowed (below).

Check openers raised (page 33).

Engage transport locks (page 35).

Set tractor for fold (page 36).

Fold wings (page 37).

Tilt up wings (page 38).

Engage transport hook (page 39).
Folding: Check Drill Configuration
1. Make sure
markers (page 60),
auger (page 52) and
ladder (page 44)
are secured in transport positions before unfolding.
2. Raise openers (page 33).
Refer to Figure 27
3. Check that transport hooks are fully lowered
(cylinder fully retracted). If not, Retract hook circuit
as needed.
4. Move to level ground.
Folding: Engage Transport Locks
Refer to Figure 28
At wing end , mid wing , and side of mainframe ,
on each side (6 locations total), reconfigure locks from:
FIELD to ROAD
Figure 27
Transport Hook Ready for Fold
29399
Figure 28
Transport Lock Locations
29423
1
2
3
1 2 3