Document #
TLUS400C-0001A
3 of 3
Hydraulic Depth Stop:
The hydraulic depth stop will maintain
constant depth every time the implement is raised and low-
ered. Adjust the per the following:
1) Simply screw the depth stop handle in to run the implement
shallower. Unscrewing the depth stop handle will allow for the
implement to run deeper. One full turn of the depth stop handle
is equivalent to 1/4” of working depth.
Note: If after setting the
depth stop, the detent on the tractor kicks out before the stop
contacts the button of the depth stop, slow the tractor hydraulic
flow down. Do not adjust the rebound valve without first con-
tacting the factory service representative.
48654
Rear Attachment Settings
Spike Drag Settings:
On the spike drag, start with 5 links
hanging from the chain in drag arm bottom slot. (This is a start-
ing point for worst conditions). The cleaner the ground, the
shorter the pull chain may be pulled up.
On the spike drag, one of the links in the first row of angles is
turned over to allow the trash to start flowing through the drag
easier. Note: Make sure that the drag is never pulling off of the
hang chains, if so, shorten the pull chains.
Heavy Coil Tine Settings:
The factory setting will have the
spring pre-set at 3-3 1/2” of bolt left to adjust. To adjust the
down pressure:
1) Loosen the jam nut (5) and screw the spring bolt (6) in to
apply more down pressure on the drag, or adjust the bolt out to
apply less down pressure.
2)Re-tighten the jam nut (5) to secure all adjustments.
5
6
48655
48653
3) To change the angle of the coil tine, rotate the locking pin (7)
and move the adjustment lever (8) forward or backwards. Mov-
ing the lever towards the rear of the machine makes the drag
more aggressive while moving the lever towards the front of
the machine will allow residue to flow through easier.
The adjustment lever has four positions and will change the
coil tines several degrees.
4) Rotate the locking pin (7) back to its engaged position when
the desired angle is achieved.
7
8
48656
Reel Settings:
If a reel is added to the back of the Ultra-
Chisel, adjust the amount of down pressure by either shorten-
ing the springs for less pressure or lengthening them for more
pressure:
