GREAT PLAINS 5109, Operator'S Manual

Page: 19 / 38

TC5109-5323 Table of Contents Index Preparation and Setup 15
07/11/2018 Table of Contents Index 566-224M
Transport Locks
Refer to Figure 7
10. Once the cylinders are connected, raise the unit
completely. If the transport locks are in place,
remove them at this time.
Refer to Figure 8
11. Store the transport locks on the lift mechanism link
as shown.
12. Once the locks are removed, unfold the wings (if
folding unit).
 Make sure no one is under the wings during the
unfolding process. Watch for leaks and make sure
hoses do not get pinched during the initial unfolding
process.
13. Once the machine is unfolded, raise and lower the
machine several times to purge air from the lift
system. Again, watch for any leaks and tighten if
necessary.
14. Check the tire pressure for proper inflation and
check the tightness of lug bolts.
First Time Field Adjustments
Pre-Leveling of Machine
 Pre-leveling of machine should be done on a good
level surface.
Front to Rear Leveling
Refer to Figure 9
15. Lower the machine until the front row of shanks are 1
to 2” above the surface. At this point, remove the
snap wire pin from the turnbuckle lock , swing
lock off turnbuckle and adjust the hitch turnbuckle
to adjust the fore and aft. The front corner of the
main frame should be
1

2
to 1” lower than the rear
corner.
16. Now the turnbuckle lock may be swung back onto
hitch turnbuckle and the snap wire pin may be
re-installed.
1
Figure 7
Transport Locks
41981
1
2
Figure 8
Transport Locks Storage
42673
2
1
2
3
Figure 9
Hitch Turnbuckle Adjustment
41805
1 2
3
2
3 1